Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-28-2006, 11:19 PM
|
#17 |
|
Import Slayer
Join Date: May 1999
Posts: 2,241
|
Re: Go get some, 82GT!
It's been suggested on fordmuscle that my carb. is leaning out on top end due to possible jetting, float levels.
I bought the carb. rebuilt from Ebay but I never checked the floats because I thought it would already be done. I was told you can't really adjust floats accuratly unless it's on the car. I'm going to check them and the filters. If the flaots are too low, the pump might not be able to keep up on the top end. These new low end numbers are good enough for 12's now but I just have to get this fuel problem solved.
__________________
'82 GT 351W (.060)Comp Cams 274* Extreme Energy cam, ported & polished heads w/ 1.94/1.60 valves 10.3:1 flat top pistons,stealth intake, Mallory dizzy,Holley 750dp carb, BBK shorties,Flowmaster exhaust,C-4 with 3700 stall converter, B&M pro shifter,8.8 rear, 4:10's, subframes, electric fan, powermaster alternator, 4 core radiator. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 82GT interior ???????? | 84GT350-1 | Blue Oval Lounge | 1 | 02-07-2004 08:33 AM |
| building a 351 | Alex89GT | Windsor Power | 5 | 06-10-2003 02:49 PM |
| New Exhaust for 82GT | midevialgnight | Windsor Power | 2 | 04-21-2003 11:21 PM |
| Can I use a vacuum gauge? | Bad89stang | Windsor Power | 10 | 12-08-2002 02:10 PM |
| My '82GT is almost ready!! | 82 GT | Windsor Power | 4 | 07-07-2001 10:26 PM |