Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-17-2006, 03:59 PM
|
#21 |
|
Rat Killer
Join Date: Aug 2002
Location: Cold ass Ohio
Posts: 1,143
|
Re: Holley carb. gurus needed!
There is absolutely NO WAY I would start playing with transfer slots, and drilling holes in the butterflies until I got the idle screw issue figured out.
I'm with Brian on this one, that motor isn't going to want to idle much below 950 rpm at best, if that's where she's happy, then that's where she needs to be. You may however find that changes once you get your issue figured out. Exactly which carb are we talking about? Some models, that screw adjusts the air/fuel mixture for the idle circuit, on other it does not. TRUST ME, read on. On MY carb, those screws did squat for air/fuel ratio. That is determined internally, all those screws did was adjust the AMOUNT of air/fuel that got fed through the idle circuit. Yes, I learned that in the book too. heehehe Brian, we need to make you a "book on tape" so you can listen to it on your way to work! hehehehehe
__________________
d-Con Racing "Nothing fancy, just 347 inches of RAT POISON!" MICE need not apply..... 
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Calling Jester and all Carb guru's | rwhite65 | Windsor Power | 7 | 09-23-2005 10:38 AM |
| Holley Carb | Hitman73 | Classic Mustangs | 15 | 07-18-2005 06:35 PM |
| this carb adapter plate for a straight six goes to which holley 2 barrelcarb | daccrow86 | Classic Mustangs | 0 | 09-23-2003 10:23 AM |
| 850 cmf holley race carb. | 69fastback | Classic Mustangs | 0 | 12-21-2001 12:13 AM |
| 650 DP Holley Carb on 390 | RedLilPony | Classic Mustangs | 12 | 03-08-2001 02:34 PM |