Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-16-2006, 05:40 PM
|
#2 |
|
Mustangs
Join Date: Jul 2000
Posts: 1,938
|
Re: Crankshaft front seal leak
removing the timing cover is pretty easy, the hardest part is getting off the harmonic balancer bolt which is usually on there pretty tight.
if i remember correctly, you could take off the front cover and EASILY remove the front crank seal. it would also be a good time to replace any other seal/gasket in the area, as well as replace the timing chain. good luck, it's not that bad of a job. you can even leave the water pump attached to the front cover.
__________________
2005 Suzuki Hayabusa GSX1300-R 1980 Ford Thunderbird - 255 V8 ported heads, 5.0L ported stock headers, O.R. H-pipe and Flowmaster 2-chambers, dual roller timing chain hi-po Mack Truck hood emblem  1985 Mustang GT 5.0L T5, F-303, GT40p, headers, off-road h, flowmasters, MSD stuff, etc. Sold 02/06/04  1989 Mustang GT ET: 13.304@102.29 mph (5-24-03) Sold - 1998 Mustang Cobra coupe, 1/4 mile - street tires: 13.843@103.41 (bone stock) |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Front seal removal on C-4 | 82 GT | Windsor Power | 2 | 08-12-2003 07:48 AM |
| Front cover leak | BLACK85GT | Small Ponies | 2 | 03-10-2003 12:23 AM |
| Front windshield seal replacement + body work | Fox Body | Appearance & Detailing | 2 | 10-03-2002 04:27 PM |
| HELP!!! Front crank seal??? | Chris_H | Windsor Power | 1 | 09-27-2002 05:11 AM |
| Front crank seal leak? | poopstang | Windsor Power | 7 | 05-14-2001 04:39 PM |