Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-18-2006, 08:18 PM
|
#6 |
|
Registered Member
Join Date: Jun 2000
Location: Sherman, Texas
Posts: 188
|
Re: Pertronix Ignition
Well, my problem is deeper than I thought. With my new Pertronix module installed I tuned the carb tonight and the car was running great. Then after about 10 minutes of running it died. I mean it just quit and would not fire. After about 10 minutes of deep thought and some expletives I took the distributor cap off to check the module. The module was so hot I could hardly hold onto it. Should it be that hot? Is it possible that my distributor is failing and causing the module to overheat and fail? I'm grasping at straws here. HELP!!! E.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| hot ignition coil? | dagit | Classic Mustangs | 3 | 11-10-2005 11:40 PM |
| Ignition Confusion | SCHOONER | Classic Mustangs | 0 | 08-16-2005 10:43 PM |
| ignition circuit problems | Justin 66GT | Classic Mustangs | 0 | 01-05-2005 11:37 AM |
| ignition switch gremlins ( long post? bear with me) | Marc91gt | Windsor Power | 1 | 09-04-2003 09:05 PM |
| Ignition frabrication...needs some ideas | 1989_351W | Windsor Power | 0 | 08-11-2001 04:52 PM |