

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Ride Hard
Join Date: Oct 2000
Location: Wyoming IL
Posts: 1,094
|
![]() This is pretty much what you are gonna hear on this board.
An auto usually the 3.80, a manual would get a 4.10 ratio. Personally, if it were my car and I was not gonna see a lot of highway miles, I would go higher with the 4.10 whether the car was amanual or auto. If your engine makes a lot of power, but you only have a 3 speed auto or an older 4 speed stick, you could probably get by with the 3.80 and still have a decent cruising rpm. Ryan
__________________
65 Fastback 91 roller 306, H/C/I AOD-Bauman, PI Stallion, 4.10's and traction loc 04 Grand Cherokee Freedom Edition 79 Ford F-250 4x4 - Restored |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Changing Rear End Gears...HELP | bigdaddy999 | Windsor Power | 4 | 08-08-2005 06:34 AM |
question on fuel system and rear gears and launching | vetteeatr | Windsor Power | 1 | 08-12-2001 05:28 PM |
Gears, need help!!!! | Edgar Negron | Windsor Power | 3 | 05-27-2001 03:10 PM |
Rear gears | dinomite | Corner Carvers Delight | 3 | 05-08-2001 05:25 PM |
Recall 01S15 Rear Knuckle replacement | folthoff | Special Production | 0 | 05-02-2001 08:28 AM |