Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-05-2007, 09:45 AM
|
#3 |
|
Registered Member
Join Date: Apr 1999
Location: Cincinnati,OH
Posts: 1,511
|
Re: Rust on stock exhaust + more
For the rear axle I'd remove the rust with a wire brush/ sand paper and hit is up with some undercoating/paint. The drive shaft you could paint but you could also throw it out of balance(probably not but it is a possibility). The exhaust there isn't much you can do, it's going to rust, unless you have it coated or it's stainless steel.
__________________
89GT,Pro-Bullet 306, H/C/I and a bunch of other stuff. *Sold* 00GT, Vortech S-Trim, Steeda Boost Pipe, C&L intake, Mac off-road H-pipe, Flowmasters, B&M Ripper shifter, Eibach Sportline springs, Koni Struts/shocks, MM full length subframe connectors, Cobra brakes, 3.73's. My Car Domain Page |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| bye bye stock exhaust | GhettoPop | Windsor Power | 6 | 07-11-2003 02:49 PM |
| Stock Cobra exhaust worth anything?? | Dark_5.0 | Modular Madness | 3 | 01-02-2003 05:26 PM |
| Gutted stock exhaust | surfbeast | Modular Madness | 1 | 09-19-2002 11:51 AM |
| Removing Stock Exhaust | spyder210 | Modular Madness | 3 | 07-15-2002 01:00 PM |
| stock exhaust on 01 GT | jsh | Modular Madness | 1 | 01-18-2002 11:29 PM |