

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Registered Member
Join Date: Apr 2001
Location: Gallatin, Tn
Posts: 1,326
|
![]() What's the timing set to?
__________________
![]() |
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: Aug 2003
Location: Airdrie, Alberta - Canada
Posts: 28
|
![]() The timing is set to 10 deg, I have verified that the timing marks are accurate. I have also tried advancing timing at 12 and 14 deg - still no change. I haven't taken it out yet this year, I will clean the MAF and try that hopefully this weekend.
|
![]() |
![]() |
![]() |
#3 |
Registered Member
Join Date: Apr 2001
Location: Gallatin, Tn
Posts: 1,326
|
![]() Did you get a chance to clean the MAF this weekend? Also, what kind of plugs did you put in when you put the new ones in? On the timing, I have to ask, did you pull the spout connector out when you set the timing, and remember to put it back in? I've had that happen before.. Also, try pulling any codes, see what comes up.
__________________
![]() |
![]() |
![]() |
![]() |
#4 |
Registered Member
Join Date: Aug 2003
Location: Airdrie, Alberta - Canada
Posts: 28
|
![]() I finally got the car out for a spin. I cleaned the mass air and took for a 20 min. run, so far so good - feels like a different car now. Doesn't look the I will get the car out for awhile now, getting another dump of snow as I write this message.
I installed NGK plugs. I did remember to pull/replace spout when setting timing. I have not checked for any stored fault codes - but I was never getting a check engine light coming on. Thank you for the reply's. |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help!!! Engine ticking - loss of power!!!! | Notchback5.0L | Windsor Power | 2 | 06-05-2003 06:22 PM |
Cutting Tips | 1989stanger | Windsor Power | 1 | 11-24-2002 05:37 PM |
Detailing engine bay...What to do about the ugly power steering pump? | Fox Hound | Windsor Power | 2 | 09-28-2002 08:44 AM |
cutting out up top | LX XLR8R | Windsor Power | 0 | 08-20-2001 03:37 PM |
car cutting off | red5.0 | Windsor Power | 4 | 01-05-2001 03:12 PM |