Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-30-2007, 10:13 PM
|
#7 |
|
Registered Member
Join Date: Dec 2006
Location: new york
Posts: 482
|
Re: 4 cylinder 5 speed work on 5.0?
my buddy put a 4cyl in his stock v8 ..just bolted right in..lasted about 300 miles with a 200 shot of nitrous..if u have souch problems stop getting the t5 trannsy and get a tremec.you will never look back
__________________
347 stroker all forged,arp everything,stud mains w/girdle,7qt pan,full roller, custom cam, aluminum heads swirl valves 5 angle valve job.quick fuel 750,areomotive pump,cobras w/nitto drags,and m/t et drags for the track, ford racing 373 gears,centerforce clutch,tko500,underdrive pulleys,bassani x-pipe,flowmasters ^best et so far 11.6 1.61 60ft coming soon 9sec et's  1992 mustang gt 2001 gmc 1500 4x4 78 century boat 92 skidoo |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TFS #1 cam & speed density. Will it work? | skiwesser | Windsor Power | 0 | 06-16-2004 02:57 AM |
| 8 cylinder into a 6 cylinder engine bay....? | EclipseGST303 | Windsor Power | 8 | 10-04-2002 01:57 PM |
| 8 cylinder into a 6 cylinder engine bay....? | EclipseGST303 | Modular Madness | 1 | 10-02-2002 07:31 PM |
| B303 cam w/ speed density will it work? | drtbiker | Windsor Power | 6 | 08-05-2002 09:11 PM |
| speed density setup, could this work? has anyone tried? | mikos chris | Windsor Power | 2 | 10-13-2001 02:20 AM |