Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-24-2007, 05:25 PM
|
#7 |
|
68 Coupe 289
Join Date: Apr 2005
Location: North carolina
Posts: 44
|
Re: Tire size on lowered 68
OK thanks to everyone that responded. I had her out today for her first long distance run since doing the drop and brake swap. My question is that one side seems to be lower then the other. I measures it and the drivers is a full inch lower then the passenger side. Everthing up front it new, A-Arms, Bushings, Coil Springs, Brakes, Rotors, Ball Joints, Spring seats, etc. The back measures level. What can cause this? The drivers side rubs under compression while turning but the passenger side is fine.
Any ideas on where to start to look? I really thought that new springs would have taken care of it. I measured both side A-Arms and they are equal distance off the ground but when you measure to the frame or fender well it is off by an inch. Any help would be wonderful.
__________________
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| max tire size | foxeleanorgt | Corner Carvers Delight | 4 | 10-06-2005 08:48 AM |
| max tire size on 17 rim | carlos.elliott | Modular Madness | 1 | 06-04-2004 09:56 AM |
| Tire Size | Rosco | Windsor Power | 4 | 03-25-2002 09:38 PM |
| Tire Size | GKSCOBRA | Modular Madness | 1 | 12-02-2001 04:54 PM |
| Nitto tire size, wheel size, etc. | 2FastLX | Windsor Power | 7 | 02-15-2001 04:04 AM |