Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|||||||
|
|
Thread Tools | Rate Thread | Display Modes |
10-08-2001, 12:24 PM
|
#2 |
|
Registered Member
Join Date: Apr 2001
Location: Staging lane
Posts: 4,337
|
I went from the stock H-pipe with four converters, to an off road X-pipe and knocked off 6 tenths!!! but keep in mind that I installed underdrive pullies at the same time.
------------------ 88 mustang gt convertible bored to 306 BBk equal length headers, mac cold air fender kit, 3.73 FMS gears, Steeds Tri-ax shifter, Steeda underdrive pullies, Custom off road X-pipe, 2 chamber flow masters, cowl hood, nitto drag radials, ford racing clutch, 160* thermostat 16 degrees of timing electric fan off 94' t-bird jacobs electronics cap and wires. Edelbrock 1 1/2 inch drop springs. (Best E.T. 14.79@93mph @3000ft) |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Off road pipe vs. Catalitic Pipe | Kamaro Killer | Windsor Power | 7 | 04-04-2002 04:05 AM |
| 2 Q's - Wheel spacers and Off road pipe | SteveK | Modular Madness | 5 | 02-22-2002 10:41 AM |
| What off road h-pipe matches up best with BBK equal length headers | Dark_5.0 | Windsor Power | 4 | 08-13-2001 06:13 PM |
| BBK 1-5/8" Equal Legnth Shortys, 2.5" Off Road H-Pipe, & Dynomax Super Turbo Cat-Back | BowTie Eater 5 Liter | Windsor Power | 15 | 08-09-2001 10:54 PM |
| 2 chamber Flow with Off road H pipe | evilmustang | Windsor Power | 2 | 06-19-2001 08:13 AM |