

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#4 |
Registered Member
Join Date: Feb 2006
Location: Santa Fe NM
Posts: 48
|
![]() I opened the drivers side, everything looks clean (new mexico car no rust). It seems to be binding. I thought that maybe the relay was stuck locking both sides, but it does it even with the battery disconnected. When you push on the manual lock it doesn't even move. Nothing is bent . Nothing obvious very strange, thats why I posted. Iwas hopeing someone had seen this problem before. Looks like I might have to cut the door panel a bit to get a better look ( it's pretty hidden where the locks are).
__________________
2003 Cobra Torch red 10 anniversary 2.8 ultra grip upper pulley, 100mm aux. idler, 100mm idlers, custom predator dyno tune (467hp,505tq), K&N cai, BBK offroad X pipe, Magnaflow cb, centerforce clutch, bbk billet quadrant ,UPR firewall adjuster w/ stock cable, MGW short throw shifter, autometer boost, kenne brown hard launch kit with derlin bushings, and BFR G-Force tires (315-30-18 dr's rear) My Car |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Door Lock probelm | DrPhilgood | Classic Mustangs | 4 | 02-24-2004 11:02 AM |
Door lock installation | DrPhilgood | Classic Mustangs | 4 | 02-03-2004 10:41 PM |
door lock actuator | richie | Windsor Power | 2 | 08-03-2001 09:46 PM |
How do I remove the door lock actuator | tomazzzo | Windsor Power | 1 | 06-24-2001 08:48 AM |
Door Lock Actuators | 86StangGT | Windsor Power | 2 | 06-18-2001 06:40 AM |