Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-09-2008, 09:07 PM
|
#2 |
|
Registered Member
Join Date: Mar 2000
Location: Berwick,Pa
Posts: 127
|
Re: plugging the EGR crossover holes
i plugged mine when i still had ported e7's by cutting the blocks of the ends of the pipe and flipping them around so the flat side was against the holes. it worked for me. i don't think the holes are threaded. i've got 3 sets of these in the garage so i'll look tomorrow if i get a chance.
__________________
'89 GT hatch back performer rpm intake, performer rpm cylinder heads, fms e-303 cam, kirban adj fp regulator, holley 65mm tb, harland sharp 1.6 roller rockers, alum driveshaft, 3.73 gears (283 rwhp, 303 rwtq new numbers with new heads) |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5.8L crossover tube | blk88lx | Windsor Power | 2 | 03-21-2003 10:06 AM |
| 10 Holes | Roadwarrior5.0 | Windsor Power | 1 | 02-25-2002 03:00 PM |
| Rear water crossover on my intake? | Phantom5oh | Windsor Power | 7 | 01-04-2002 10:31 AM |
| Crossover? | 5.0L_Of_Fury | Audio, Security, & Electronics | 1 | 09-12-2001 11:56 AM |
| Plug Exhaust crossover? | weagle | Windsor Power | 6 | 07-13-2001 02:40 PM |