Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-21-2008, 12:55 PM
|
#1 |
|
Registered Member
Join Date: Feb 2005
Location: Minneapolis USA
Posts: 31
|
Re: plugging the EGR crossover holes
once again, i did make a mistake in talking about the crossover tube that goes from one head to the other in the back which is for the thermactor system NOT the EGR.
but, since you asked jwilliy.... i believe that the EGR spacer gets its exhaust internally. by that i mean i think it comes up from the heads through the intakes to the EGR spacer all internally through a special hole. when its called for the EGR spacer valve opens and the exhaust gets routed into the intake. there is an electrical connection and a vacuum line on my 89 mustang gt to the back of the EGR spacer. went out and looked and i see no external tubes from the exhaust. cant help you with the other stuff |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5.8L crossover tube | blk88lx | Windsor Power | 2 | 03-21-2003 10:06 AM |
| 10 Holes | Roadwarrior5.0 | Windsor Power | 1 | 02-25-2002 03:00 PM |
| Rear water crossover on my intake? | Phantom5oh | Windsor Power | 7 | 01-04-2002 10:31 AM |
| Crossover? | 5.0L_Of_Fury | Audio, Security, & Electronics | 1 | 09-12-2001 11:56 AM |
| Plug Exhaust crossover? | weagle | Windsor Power | 6 | 07-13-2001 02:40 PM |