
© Copyright 2026 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
#6 |
|
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
Yeah that's a good point about running low on fluid. I lost all 3 gears when trying to get her home during the massive leak. Ended up about a 1/4 mile away when I lost all my gears. Tranny was bone dry. I'm running a temp gauge and didn't notice any increase in temp so hopefully it's ok internally. I'm going to bring it back down to Harold at Dynamic Racing to have them look at it. I went with the automatic setup over a 6 speed b/c I figured it'd be more reliable. But maybe the 2500-3000 rpm traveling on the highway to the track hurt it? I can't imagine 30-40 12 second passes on a tranny that's made for 8 second Stangs did any abnormal wear.
This wasn't a cheap tranny at all...I'm a bit surprised (and disappointed) that seals are going this soon.
__________________
Red 1993 GT Street Machine Best E.T. - 12.41/Best MPH = 108 Engine is a 1969 351 block w/393 stroker kit. Dynamic Roller Myte C4, 8 pt cage. Edlebrock Performer heads and Victor Jr. EFI, FRPP 30lb injectors & Cartech fuel system. MSD ignition. Sothside Machine bars & Sub-frames, adj. upper's, 3.73's, Koni rear shocks, much more |
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| main seal.. | 89GTimporteater | Windsor Power | 5 | 11-26-2003 01:50 PM |
| rear main seal | racerx0071 | Windsor Power | 1 | 02-19-2003 02:18 AM |
| Rear Main Seal | 1hot5.0 | Windsor Power | 9 | 09-10-2002 06:22 PM |
| Rear main seal | RPM427 | Windsor Power | 6 | 06-24-2002 11:42 AM |
| Rear main seal on 87 2.3L | Radon | Small Ponies | 1 | 02-20-2001 03:08 PM |
