Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-10-2001, 11:23 PM
|
#2 |
|
Registered Member
Join Date: Apr 2001
Location: Goin somewhere, USA
Posts: 215
|
headers always seem to be a pain in the *** to install....
but a header gasket is the same as the exh manifold gasket! just gotta be sure to get ALL of the old gasket off or you'll get a leak!! I had to use a dremel to remove the old gasket sealed to the heads on mine.. always check the bolts after a few miles to be sure they are still tite!! ------------------ 84 GT,shorty headers, open dual's, bored .060, 10.5" clutch, T5, 89 heads, edelbrock Performer manifold, matched cam, 600 Holley.. never enuff & always learning.. the only sound, better than a strong running V-8, is a woman having the big 'O' |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Shorty headers (equal length) | titanium92 | Windsor Power | 9 | 08-22-2004 09:18 PM |
| Equal or Unequal length shorties?? | SCOTTLT79 | Windsor Power | 2 | 07-28-2002 05:27 PM |
| Installing BBK Equal Length Shorties! | Mac_5.0 | Windsor Power | 10 | 07-07-2002 11:59 PM |
| BBK Equal Length Shorties - Install Question | Mac_5.0 | Windsor Power | 3 | 06-12-2002 07:50 AM |
| Head Gaskets, Header Gaskets, Intake Gaskets, etc | AxemanZZ | Windsor Power | 8 | 01-11-2001 01:09 PM |