Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
10-05-2001, 11:23 PM
|
#1 |
|
Registered Member
Join Date: Apr 1999
Location: Hayes, Va, USA
Posts: 798
|
AFR 165's for a 302, would work real nice with an Edelbrock Performer RPM or Holley intake.
I finally got my set of 185's talk about a peanut port flowing real good, On my engine builders flow bench they peaked at 276 cfm and are on the smallish side of a 1262(?) gasket. Anywhosit, if your planning on running an Victor 5.0 efi intake with the 185's. Forget it and move upto the 205's and save a little bit of money or else you'll be doing a port match and some blending just to get the intake to match up. [This message has been edited by MiracleMax (edited 10-06-2001).] |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Confused on head bolt torque. | Dark_5.0 | Windsor Power | 4 | 08-28-2003 03:46 PM |
| Broke bolt in new head (Kinda Long) | 1988GTCONERTIBLE | Windsor Power | 6 | 05-12-2002 02:00 PM |
| head bolt question... | avbcon12 | Windsor Power | 4 | 02-23-2002 09:13 AM |
| boss 302 head bolt | markduanetaylor | Classic Mustangs | 1 | 06-22-2001 10:18 PM |
| boss 302 head bolt (1969) | markduanetaylor | Windsor Power | 1 | 06-22-2001 03:45 PM |