Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-01-2009, 04:00 PM
|
#4 |
|
Registered Member
Join Date: Dec 2009
Posts: 6
|
Re: Speakers in '86 Dash
11 total screws to remove the dash pad: one on each end of each defrost vent, two above the glove box, and two behind the instrument panel trim, which is itself held on by three screws that go up into the dash pad. As was said, there are two 3.5" speaker mounts at the corners, and 1 5x7" mount in the center (used for the amp in the premium systems; was for a single speaker in old AM-only mono radios).
You might call Matt at Fox Mustang Restoration about a reproduction dash pad; I saw a thread at FourEyedPride.com a while back where he was working on getting a better quality reproduction made. Not sure if they're available yet or not.
__________________
-BK '01 Cobra '84 1/2 GT T-top |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mach 460 Speakers for 04 Mustang Convertible | marly | Audio, Security, & Electronics | 0 | 08-28-2005 10:20 PM |
| Can I run a 4-ch. amp and just dash and door speakers thru my factory cassette? | 11Sec_Lx | Audio, Security, & Electronics | 1 | 09-01-2003 09:18 PM |
| aftermarket speakers with mach 460 | ac97gt | Audio, Security, & Electronics | 0 | 06-15-2003 11:33 AM |
| MACH 460 rear speakers | shannon2461 | Audio, Security, & Electronics | 2 | 07-23-2001 07:51 AM |
| 3.5" or 4" speakers in dash? | BowTie Eater 5 Liter | Windsor Power | 9 | 01-23-2001 01:39 AM |