Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-10-2001, 04:37 AM
|
#2 |
|
Registered Member
Join Date: Sep 2001
Posts: 13
|
I assume you mean hydraulic roller. To make one fit you'll need either a retro-fit roller kit and cam or buy the retro roller lifters from Crane and run any hydraulic roller cam. The lifters are expensive but no machine work is needed to make them fit the block and no special cam is needed when using those. If you do the retro roller kit you have to have some machine work done to the block and purchase a smaller circle base cam to fit with those.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Motor Swap questions 88 cougar to 84 stang | 5.0 Fiend | Windsor Power | 33 | 08-25-2004 07:41 PM |
| Couple of quick, stupid questions! | SCOTTLT79 | Windsor Power | 4 | 02-15-2003 04:02 PM |
| A couple hot weather questions..... | MattwantsSpeed | Windsor Power | 17 | 08-24-2002 08:44 AM |
| Have a couple of questions... | physicusstang | Windsor Power | 2 | 08-28-2001 09:27 PM |
| more turbo swap questions | Trevor | Small Ponies | 7 | 08-29-1999 05:45 PM |