Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-12-2001, 02:11 PM
|
#3 |
|
Registered Member
Join Date: Jan 2000
Location: greenvile, NC
Posts: 161
|
Sounds like the distributor is off a tooth? When you set it at 12 did the distributor look like it was in the right position? You can be off a tooth and still set the base timing right, it will not run right though. It will buck.
------------------ 89'notch 331ci Scat Stroker, Stage II Holley heads, ported Holley Systemax Intake, 70mm Holley TB, 50lb Holley Fuel Injectors, 80mm Pro-m MAF, AFM B-3 cam, Vortech S-trim Supercharger, AFM Powerpipe, EEC-Tuner, TKO, Koni, Eibach, HPM, etc... Beaten Daily.. http://lowkey.stangnet.com |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Total timing vs initial timing for max HP. | Dark_5.0 | Windsor Power | 35 | 04-28-2009 11:35 PM |
| gapping plugs to 60 worth it on a 98 gt with timing at 14 degrees? | slow98 | Modular Madness | 2 | 03-27-2003 10:34 PM |
| Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
| points and timing specs | xfernal | Classic Mustangs | 1 | 12-30-2001 04:20 PM |
| setting timing at 14 degrees | 82 GT | Windsor Power | 4 | 04-05-2001 10:36 PM |