Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-18-2001, 01:07 PM
|
#14 |
|
Registered Member
Join Date: Aug 2001
Location: Palm Beach Gardens, Florida, USA
Posts: 191
|
I am going to Rieth Motorsports this Saturday-Steve is installing the 4.10's in my '95. I'll ask him about the chip for you as I will be looking for a custom burn when I install my upper half (cam, heads, intake, etc.). I'll post his answer or e-mail me privately. My address is in my profile.
------------------ Todd 1995 GT/T-5 Pulleys; 65 mm TB; Flowmaster cat-back; Mac off road H-pipe; FMS aluminum driveshaft; short-throw shifter; HD clutch; Cobra R's; Cobra front and wing |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need chip for blown 331... Questions??? | Coolbreeze | Power Adders | 2 | 01-09-2004 02:28 PM |
| Need Help! Can anyone answer any of my questions? | SmokinStangGT | Windsor Power | 4 | 08-02-2003 07:41 PM |
| Bottom Line With Mass Air Meters | gtsr515 | Windsor Power | 13 | 04-27-2002 01:40 PM |
| Custom burned chip questions | 2FastLX | Windsor Power | 2 | 05-01-2001 03:45 AM |
| Dan can you filter out chip question's? | fiveohpatrol | Windsor Power | 8 | 01-26-2001 08:55 PM |