Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-31-2001, 03:45 PM
|
#2 |
|
Moderator
Join Date: Mar 2001
Location: Myrtle Beach SC
Posts: 1,643
|
I think that is correct. I am not sure as I dont keep up with much vert stuff but that sounds right. Someone else will have to chime in just to be sure.
------------------ '93 lx notch 4 banger (drive it to work currently), Using the 306, 8.8 posi, 4.10's, summit rear cover, elec. fan, cowl hood, wieand stealth intake, Heddman 1-3/4 long tubes, holley 650 d.p.carb., built c-?, e-303, full autometer guages, msd box, mallory unilite dist, and coil, roll cage, summit seat, subs, 15x10's in the back with slicks, skinnies up front, custom dash, all in use for 1988 Hatch Drag Car. Heres my site. http://www.angelfire.com/extreme2/ponypower |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 8-point competition engineering roll cage | Dog5ohfun | Windsor Power | 3 | 02-23-2004 01:34 AM |
| Questions on Roll Cages, Welding, and Ignition | BlackFireN2O | Windsor Power | 3 | 08-25-2002 08:01 AM |
| Quick Question about Roll Cage/Race seat compatibility | Fox Body | Windsor Power | 4 | 03-15-2002 01:16 PM |
| Gathering info on roll cage installation. | Fox Body | Windsor Power | 5 | 02-25-2002 11:35 PM |
| Roll Bar for a vert? | Chipdog | Windsor Power | 7 | 10-16-2001 05:07 PM |