Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-31-2001, 04:52 PM
|
#5 |
|
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
Yes it is 13.99 for a vert. The local tracks here will let you slide if you go in the 13.90's range most of the time but if you get any quicker they will flag you.
It is 11.99 for a Hardtop  ------------------ Check Out My Site 91GT,Speedbrain ECU,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,30#,76mm C&L,75mm Accufab, Full MAC, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension, SPEC stage III clutch, Lakewood SFI bell, S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 33 splines coming very soon! <B [This message has been edited by Rick 91GT (edited 10-31-2001).] |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 8-point competition engineering roll cage | Dog5ohfun | Windsor Power | 3 | 02-23-2004 01:34 AM |
| Questions on Roll Cages, Welding, and Ignition | BlackFireN2O | Windsor Power | 3 | 08-25-2002 08:01 AM |
| Quick Question about Roll Cage/Race seat compatibility | Fox Body | Windsor Power | 4 | 03-15-2002 01:16 PM |
| Gathering info on roll cage installation. | Fox Body | Windsor Power | 5 | 02-25-2002 11:35 PM |
| Roll Bar for a vert? | Chipdog | Windsor Power | 7 | 10-16-2001 05:07 PM |