Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-02-2001, 10:52 PM
|
#14 |
|
Registered Member
Join Date: May 2001
Location: Antioch, CA 94521
Posts: 181
|
Well tomorrow I'm gonna go and see if I can get into the 13's. Any last minute advice anyone such as:
lower tire pressure in rear tires. Lauch with rpms at I don't know, I guess 1600. have a quarter tank of gas or less. etc ------------------ 94 GT convert:TFS twisted wedge heads, TFS street intake, Lunati cam .500/.510 218/226, BBK FPR, BBK shorties, BBK 70mm tb, Pro-m 75mm, ASP pulleys, FMS 3:73, Transgo shiftkit,Flowmasters, Bassani x-pipe, K&N FIPK, FMS 1.6 roller rockers, 9mm wires,24lbs injectors, 190lph fuel pump, MSD cap and rotor, 18" wheels w/street tires, JMS custom chip, Trickflow phenolic spacer, 180* Thermostat, 14 degrees of timing. ETs soon to come... |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 8-point competition engineering roll cage | Dog5ohfun | Windsor Power | 3 | 02-23-2004 01:34 AM |
| Questions on Roll Cages, Welding, and Ignition | BlackFireN2O | Windsor Power | 3 | 08-25-2002 08:01 AM |
| Quick Question about Roll Cage/Race seat compatibility | Fox Body | Windsor Power | 4 | 03-15-2002 01:16 PM |
| Gathering info on roll cage installation. | Fox Body | Windsor Power | 5 | 02-25-2002 11:35 PM |
| Roll Bar for a vert? | Chipdog | Windsor Power | 7 | 10-16-2001 05:07 PM |