

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#16 |
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
![]() Yes that leak did slow you down and with traction that is a 13 sec car, the 2.33 60ft is killing you.
I found on street radials is is best just to drive off the line, I was able to get a best of 13.20 @ 104 1.80 60ft on the stock motor, added D.O.Ts went 12.87 @ 104 1.60 60ft. ------------------ Check Out My Site 91GT,[bSpeedbrain ECU[/b],Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,30#,76mm C&L,75mm Accufab, Full MAC, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension, SPEC stage III clutch, Lakewood SFI bell, S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 33 splines coming very soon! <B |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
8-point competition engineering roll cage | Dog5ohfun | Windsor Power | 3 | 02-23-2004 01:34 AM |
Questions on Roll Cages, Welding, and Ignition | BlackFireN2O | Windsor Power | 3 | 08-25-2002 08:01 AM |
Quick Question about Roll Cage/Race seat compatibility | Fox Body | Windsor Power | 4 | 03-15-2002 01:16 PM |
Gathering info on roll cage installation. | Fox Body | Windsor Power | 5 | 02-25-2002 11:35 PM |
Roll Bar for a vert? | Chipdog | Windsor Power | 7 | 10-16-2001 05:07 PM |