Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|||||||
|
|
Thread Tools | Rate Thread | Display Modes |
11-07-2001, 08:27 AM
|
#3 |
|
Registered Member
Join Date: Nov 1998
Location: Sugarland, TX USA
Posts: 161
|
pony_power_90,
No problem at all. I enjoy the questions. There are several other companies that make a drag race rear anti-sway bar. Wolfe, Racecraft, BBK and Maximum Motorsports are a few. I haven't seen any others with this hole drilling problem like the CE. I have it on and completed so hopfully it will perform. I am dynoeing 360 hp with over 500 lbs of torque. With my light car I got to have slicks. And Hoosier slicks at that. I tried M/T Drags and they wouldn't hold at all. I'm running factory control arms with polyurethane bushings. They seem to be holding up all right. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Does anyone have a Competition Engineering anti roll bar on there car? | topher5_0 | Windsor Power | 0 | 02-21-2002 07:48 AM |
| Who makes a good heavy duty rear sway bar? | 8850 | Windsor Power | 5 | 10-18-2001 06:19 PM |