Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
11-06-2001, 10:28 PM
|
#1 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
whats a 73 weigh, about 4500lbs?
 i've never seen anyone modify a 73 but it sounds like your on the right track especially the tremec part, how was that to install in there? with that big of a car i'd go with a cam and rear end gear that will give you the most down low power to get it up and goin it seems you've also picked IMO the best box stock heads out right now for a 302 good luck with it, sounds like a real project ------------------ 88 Notch, B&M Ripper, 3.73's, Ported E7's, Explorer int. w/ ported lower, pulleys, 1.7RR's, full exhaust,65mm TB, Nitto DR's, new best 1/4--> 13.42@106.18 (1.89 short time) |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help I need heads!! | SmokinStangGT | Windsor Power | 18 | 05-04-2003 10:05 PM |
| New FRP Heads for 96 - 98 4.6 | surfbeast | Modular Madness | 9 | 11-21-2002 07:02 PM |
| will 99-2002 cams out of the pi heads fit in the 96-98 stock heads | slow98 | Modular Madness | 6 | 10-25-2002 04:28 PM |
| GT-40 heads | 5.0 Pony | Windsor Power | 1 | 09-10-2002 10:26 PM |
| Which heads are beter? | patman | Classic Mustangs | 3 | 12-02-1999 03:42 AM |