Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-31-2001, 09:50 PM
|
#4 |
|
Registered Member
Join Date: Oct 1999
Location: Cincinnati, Ohio
Posts: 1,575
|
Yeah, it will botl right up. Just make sure you get the H-pipe for shorty headers and not full length or long tubes. It's a peice of cake to install, takes me about 15 min to swap mine out. Just make sure you have good tools and some WD-40 cause the header bolts that connect to the h-pipe are usually tight or rusted in place, so make sure you don't round off the nuts and have the socket on straight and you have the right size. Other then that your set. You will really like the results that you get. More power and a hell of alot better sound. Oh yeah, it will bolt up to the 2 1/4" flows just fine.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| h pipe or x pipe, and which ones | apowers2k | Modular Madness | 3 | 02-10-2003 12:09 PM |
| California Smog legal X or H pipe | shawv | Modular Madness | 1 | 05-08-2002 05:51 PM |
| Off road pipe vs. Catalitic Pipe | Kamaro Killer | Windsor Power | 7 | 04-04-2002 04:05 AM |
| Mac H pipe w cats vs BBK x pipe with cats?? | Chevyguy | Windsor Power | 15 | 11-16-2001 08:34 AM |
| Installing CATS in an off-road pipe | King Snake | Modular Madness | 10 | 03-27-2001 05:13 PM |