

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#5 |
Registered Member
Join Date: Jun 1999
Location: North Haven,CT
Posts: 336
|
![]() I posted the same question not too long ago. The solution for me was one of the following (not sure which because I did all three at once)
Set TPS to correct voltage. Check for vacuum leaks (I had one on the passenger side behind the strut tower) Disconnect and clean the 10-pin connector on the back of the motor One of the three worked for me for the exact same problem...good luck ------------------ 1992 5.0 LX, Edelbrock 6037 Heads, Cobra Intake,E-303, 1.6 Roller Rockers,65MM Holley TB, 75 MM Pro M Mass Air, 190 LPH FP w/ 24 lb injectors,BBK equal length shorties,offroad h-pipe,Mac Flowpath Mufflers, Pro 5.0, 3.73's,Motorsport "C" springs,welded subframe connectors, Ponies w/ 225/50 Nittos, 93 Cobra Spoiler Daily driver: 89 Coupe with 205K plus, BBK shorties,offroad h-pipe,2-chamber flowmasters with dumps, cut and welded stock shifter...and it runs like a champ. |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
1968 engine numbers, 289 or 302? | andybud | Classic Mustangs | 5 | 09-11-2003 12:14 PM |
Engine Idle Problems Continue | mimicons | Windsor Power | 4 | 02-20-2003 04:30 PM |
Vacuum reading at idle? | exgmguy | Windsor Power | 20 | 09-27-2002 06:22 AM |
Popping sound @ Idle when engine cold, any ideas?? | jetuomi | Windsor Power | 10 | 05-31-2001 12:40 PM |
Need help with idle | oldman | Windsor Power | 8 | 05-30-2001 12:50 AM |