Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-01-2001, 12:38 PM
|
#7 |
|
Registered Member
Join Date: May 1999
Location: Georgia
Posts: 3,866
|
install is similar with electrical, except your running wires instead of tubing. Forget about splicing into the tranny lines. The temp. probe screws right into the side of the case on an AOD. Remove one of the plugs, and install in place of the plug. Be professional, use high quality splice connectors, route the wires so they wont chafe or get caught in anything.
Splice the power feed for the lights off of anything with power when light switch is on...like dashlights, center console lights, etc.. ------------------ 1993 GT/AOD '93 Mustang GT |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Roller Rocker install questions. (long) | chris91LX | Windsor Power | 5 | 03-15-2001 09:32 PM |
| GT-40 Intake install on SN-95 questions???????? | cojonepony | Windsor Power | 0 | 03-09-2001 08:06 PM |
| Electric fan install questions... | chris91LX | Windsor Power | 11 | 02-27-2001 02:07 PM |
| FMS A/C elim install questions | sedanman | Windsor Power | 5 | 01-30-2001 03:25 PM |
| Do I need to use pressure plate alignment dowels with clutch install? | TROYXTROY | Windsor Power | 4 | 01-25-2001 02:12 PM |