Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-01-2001, 08:35 AM
|
#2 |
|
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
Just grab at the corners and pull up, the seat will pull up, then after both sides are up pull forward and the bottom comes right off. Make sure you remove the deadond material under the seats if you are doing any welding if not it could catch on fire.
------------------ My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Welding torque boxes...tips? | Coupe50h | Windsor Power | 8 | 03-07-2003 11:55 PM |
| Torque Boxes | Oldschoolpony | Windsor Power | 3 | 03-22-2002 09:12 AM |
| Torque Boxes | 86GT | Windsor Power | 6 | 12-21-2001 04:58 PM |
| BATTLE BOXES....when needed, and what brand? | Spenc2u | Windsor Power | 6 | 12-18-2001 08:25 AM |
| Battle Boxes... Who makes them, where do I find them...??? | WA2FAST | Windsor Power | 1 | 06-05-2001 07:12 AM |