Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-01-1999, 10:48 AM
|
#8 |
|
Registered Member
Join Date: Apr 1999
Location: Wilkes-Barre, PA 1968Mustang
Posts: 188
|
Just to help you out if correctness is important, the aluminum intake manifold was standard on the Shelby GT-350 only. It was cast iron on the Cougar, Fairlane, Montego, and Mustang. HP was correct, 290@4800rpm. Combustion chamber volume was 58.9cc - 61.9cc. Hope this helps out!
------------------ still lookin for the right stang! wilkes-barre/scranton, pa |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 351W Heads on a 87 302 Block | NitroNixon | Windsor Power | 5 | 05-08-2003 09:29 PM |
| 351W heads on 289 stock engine | sleeperstang | Classic Mustangs | 5 | 11-21-2002 08:35 PM |
| Where to find 351W SVO | GodStang | Windsor Power | 0 | 10-11-2002 02:04 PM |
| 351W in a Fox body | greydan | Windsor Power | 4 | 07-03-2002 02:33 PM |
| HP #'s from a built 351W versus FMS 351 versus stroker | stroker393 | Windsor Power | 0 | 03-09-2001 10:24 AM |