

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#2 |
Registered Member
Join Date: Mar 1999
Location: Dallas, TX
Posts: 208
|
![]() I think you should be between 13 1/2 and 14 1/2 volts, but 15 isn't all that uncommon. My 66 runs about 14 1/2 most of the time, but with out any accessories on, I can see 15 volts. Any more than this and you should worry about over charging the battery. You might try a new regulator, and see if it sets you up a little lower.
|
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about sensors and voltage | MustangGT1990 | Windsor Power | 6 | 02-06-2003 02:55 PM |
MAF tested with volt/ohm meter HELP! | BOW TIE SMASHER | Windsor Power | 6 | 10-28-2002 09:16 PM |
208 volts???? | wade73 | Modular Madness | 0 | 05-10-2002 02:38 PM |
How many volts for the T.P.S on a 70mmTB? | Thad | Windsor Power | 6 | 02-17-2002 04:19 AM |
Need help with starting problem.... | Godslayer | Windsor Power | 4 | 01-10-2002 01:59 PM |