Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
07-13-1999, 09:30 AM
|
#1 |
|
Registered Member
Join Date: May 1999
Location: Rowlett,Texas
Posts: 306
|
You might go back and see 68 289 valve clicking, I think it was posted around June 27 it has alot of input on valve adjustment.Just make sure the cylinders are lubed enough especially if it has been sitting awhile and you can even turn the oil pump before you install the dist. to get some oil moving through the system.Make sure the rotor is pointing to the #1 when your at TDC and start it up and fine tune.
|
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Valve setting techniques... | Hozer 88GTConv | Windsor Power | 6 | 03-14-2004 08:50 PM |
| valve problem | pearlgt40 306 | Windsor Power | 3 | 07-05-2003 01:21 AM |
| Setting Lash on Roller Rockers, AGAIN | ChunkFunky | Windsor Power | 5 | 04-21-2003 06:53 PM |
| valve lash | stanger8172 | Windsor Power | 2 | 11-03-2001 08:33 PM |
| PCV Valve what the ?@#$@#$@$ | Chevyguy | Windsor Power | 3 | 04-11-2001 08:01 PM |