Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
07-27-1999, 11:50 PM
|
#1 |
|
Registered Member
Join Date: Jul 1999
Posts: 26
|
Jeff,
We don't have back up lights and it has been awhile since I have seen any on the early Stangs. But, if they are mounted/secured anything like front turn signals, then you remove two small hex nuts that hold a cup like surrounding to the back of the lamp. The cup like metal piece then slides off the inside (back) of the lamp and, after disconnecting the lamp wiring plugs, you pull the lamp out the exterior of the valance panel. I am not sure, but, as with the front turn signals, there may be a right and left lamp assembly so keep the cups and lamps together, although it is easy to figure out which goes where. Good Luck! Neal |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| new rear end | fordkid68 | Classic Mustangs | 18 | 11-24-2009 08:05 PM |
| want rear disk without changing overall length of rear....please help!!! | dragstang86 | Windsor Power | 1 | 07-31-2003 06:32 PM |
| cobra rear questions | dragstang86 | Windsor Power | 3 | 07-02-2003 06:56 PM |
| installing cobra rear in my LX...picked up a totaled 93 limited edition | dragstang86 | Windsor Power | 1 | 05-26-2003 11:23 AM |
| Rear Brake Line Removal | Kisner | Classic Mustangs | 2 | 03-13-2002 12:31 PM |