Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-06-1999, 11:18 AM
|
#3 |
|
Registered Member
Join Date: Sep 1998
Location: Millburn, NJ
Posts: 310
|
You can calculate the needed speedo gear teeth with the formula below.
speedo gear Teeth=Drive Gear Teeth (Times) Axle Ratio (Times) Tire Rev. Per Mile Divided By 1000 The drive gear teeth number on a 65/66 C4 is 7, if the cougar you took the trans out of had tall gears it might have a 6 spline tailshaft (6 drive gear teeth). -JON |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| speedometer gear installation? | squid | Windsor Power | 2 | 12-12-2002 12:42 AM |
| speedo driven gear keeps getting chewed up | qwkcoupe | Windsor Power | 6 | 07-22-2002 09:56 AM |
| 3.73 speedometer gear change? | 5.0PiMpin | Windsor Power | 13 | 03-29-2002 07:06 PM |
| 3.73 Gear - Speedometer calibration | SteveK | Modular Madness | 2 | 07-06-2001 08:51 AM |
| speedometer gear | SN95 5.0 | Windsor Power | 23 | 03-26-2001 04:43 PM |