Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-02-2001, 03:43 PM
|
#2 |
|
Registered Member
Join Date: Apr 1999
Location: Nebraska
Posts: 12
|
Drudis,
I'm sure you have already found you can buy headers pre-coated. BBK uses Jet-hot on their long tubes. The added price is around $60-80. This type of coating is said to reduce underhood temps and save spark plug boots, clutch cables, and starters. If you already have the headers, some did-it-yourselfers have used POR-20. It can be brushed or air-sprayed. Check out this site: http://www.por15.com/hightempcoatings.html ------------------ 92conv, T5, HPMsubs, 4pt gload, strut tower brace, 3.55's, 3 chamber Flowmasters, Baer SS brake lines |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1 3/4 long tube header install. | Dark_5.0 | Windsor Power | 1 | 08-05-2004 01:51 PM |
| Where can I find some header bolts? | 96_4.6 | Modular Madness | 5 | 11-08-2003 10:22 PM |
| Header and Exhaust Installation | 1991GT | Windsor Power | 4 | 12-03-2002 11:17 PM |
| Whats the going price for long tube header installation? | Dark_5.0 | Modular Madness | 3 | 09-19-2002 03:29 PM |
| Header Gasket Help Needed | Phillip Long | Windsor Power | 5 | 05-03-2002 01:59 PM |