Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-11-2001, 03:09 PM
|
#2 |
|
Registered Member
Join Date: Nov 1998
Location: Houston, Tx.
Posts: 3,887
|
I'm not familiar with those headers, but 351W heads on my original 289 block fit fine in my '66 Coupe. I'm using Tri-Y headers though, and have about 1/2" clearance with the shock towers.
Rev ------------------ '66 Coupe, 306, 300 HP, C-4, 13.97 e.t., 100.3 mph 1/4 mi. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block and head machining questions | bmxmon | Windsor Power | 6 | 09-26-2004 02:21 PM |
| After all normal bolt-ons... cylinder head questions | RED92LX50 | Windsor Power | 9 | 06-14-2003 08:43 AM |
| 351 head questions on my 5.0 | vetteeatr | Windsor Power | 0 | 08-28-2001 04:03 PM |
| Edelbrock Head Install Questions | Blaster | Windsor Power | 5 | 05-10-2001 12:22 PM |
| head gasket replacement stuff questions | fiveohpatrol | Windsor Power | 4 | 04-13-2001 04:23 PM |