Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-30-2001, 02:23 AM
|
#3 |
|
Registered Member
Join Date: Nov 2000
Location: So. Cal.
Posts: 244
|
Just my 2 cents....
I had two K&N (very unrestrictive) breathers (no pcv) on my 347 when I first built it and I kept blowing the intake manifold seal out at the back of the block. Oil everywhere. After I configured a pcv in one valve cover and a breather in the other I have never had a problem. ------------------ 347 (Coast High short block), 279/284 .493/.510, TFS TW, Stealth, 750, Flowtech hdrs, Dr. Gas X, 2 Chmbr Flowmaster, MSD 6AL-Dist.& SS coil, March serpentine pulley system, Art Carr C-4, Currie 9" w/3.55, alum Drv Shft, susp mods, Total Control subframes & tower braces, Trans Am Racing power dual master, 4 wheel disc In a 66 coupe |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Air by pass valve question. | Jaegermeister2k | Power Adders | 21 | 05-06-2005 09:40 PM |
| Valve tap!! | SmokinStangGT | Windsor Power | 1 | 07-31-2003 03:42 AM |
| valve problem | pearlgt40 306 | Windsor Power | 3 | 07-05-2003 01:21 AM |
| Proportioning Valve | MidniteWrider | Classic Mustangs | 1 | 07-11-2001 09:14 AM |
| PCV Valve what the ?@#$@#$@$ | Chevyguy | Windsor Power | 3 | 04-11-2001 08:01 PM |