Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
07-30-2001, 04:11 PM
|
#1 |
|
Registered Member
Join Date: Jul 2001
Location: West Covina, CA
Posts: 77
|
Man, well, im going to spend whatever it takes. I was thinking about getting one of the summit rebuild kits, which basically includes bearings, gaskets, piston rings, and pistons for about $600. But the way i drive the car, and the way i want to kick every rice rockets @$$, the more i see that i should go balls out on this rebuild. I would be looking to spend $3000 or more if i have too. One thing though, do you guys think i should get a new tranny 1st? since it looks like it will be cheaper, i only have a 3spd, but its in good condition. I know a tranny will help my car out A LOT.
------------------ Under Construction 66 Coupe -289 V8 4 barrel Holley 600cfm carb - Headers - Flowmaster 2 1/2 dual exaust |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rare Mustangs....Got One? | 1969Mach1 | Blue Oval Lounge | 22 | 09-25-2010 04:59 AM |
| Rebuilding an engine.. and then some | Halz | Windsor Power | 5 | 04-01-2002 02:01 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |