Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-03-2001, 02:05 PM
|
#4 |
|
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
I am currently running the Holley cam .509"/.509" 102/107 218/220 @ .050 but since it broke,I looking at switching to the Anderson N-66 (.544/.568 110 lobe center 228/236) since I am fly cutting my pistonsit will fit with no issues. I was also looking at the XE282HR. I am running a 65mm Accufab right now.
------------------ My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| phenolic spacer | srv1 | Windsor Power | 4 | 09-09-2002 12:46 PM |
| Phenolic spacer just a gimmick? | mysweetlx | Windsor Power | 7 | 04-27-2002 06:23 PM |
| Phenolic heat spacer? | Extremestang | Small Ponies | 0 | 02-22-2002 12:13 PM |
| EGR bocked by phenolic spacer | red90lx | Windsor Power | 1 | 10-19-2001 03:22 PM |
| 1" Phenolic Spacer for GT-40 Intake (no EGR) - Where can I get one? | 2FastLX | Windsor Power | 7 | 06-07-2001 02:36 AM |