Bad lifter? or loose rocker?

PKRWUD · 10-31-2001, 05:35 AM

The fact that it briefly went away after tightening the rockers tells me it's an exhaust leak. The valves won't fully close right off, and the explosion in the cylinder won't occur, thus, no noise. When the engine is cold, try "feeling" for puffs of exhaust around the header/head mating surfaces with your fingers. A new gasket and double checking the header bolts periodically should help.

Rev-
FYI: I'm sure you're familiar with the "ignition wrench" set that comes with most Craftsman tool sets, with thin open end wrenches, where one end is normal and the other opens at 90 degrees. Well, the 90 degree 3/8" wrench (or 7/16", depending on your header bolts), is a godsend when it comes to hard-to-get-to header bolts. You still can't torque them, but you know how tight to go. Anyway, that wrech allows for a greater turning radius, lessening the time and frustration that goes with installing and uninstalling header bolts! Dig through your tool box and try it! I know you'll be pleased.

Take care,
-Chris

------------------
Retired Moderator
MustangNet

My site: Peckerwoods Pit Stop

My teams site: Jim Porter Racing

RACECAR spelled backwards is RACECAR

HEY !!! Are you ASE Certified ??? If you are, ask me about iATN.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
'87 351, noisy lifter, high idle.	Hozer 88GTConv	Windsor Power	1	10-06-2003 12:42 PM
What is a lifter?	SoulKeeper	Modular Madness	7	05-09-2003 10:49 AM
Lifter help please...	Falcons Talon	Windsor Power	11	09-11-2002 04:15 PM
HELP! - no oil at rocker	matt cook	Windsor Power	2	05-22-2002 10:52 AM
loose rocker??	AB89GT	Windsor Power	3	05-01-2001 11:36 AM

10-31-2001, 05:35 AM	#10
PKRWUD Junior Member Join Date: Mar 1999 Location: Ventura, California Posts: 8,981	The fact that it briefly went away after tightening the rockers tells me it's an exhaust leak. The valves won't fully close right off, and the explosion in the cylinder won't occur, thus, no noise. When the engine is cold, try "feeling" for puffs of exhaust around the header/head mating surfaces with your fingers. A new gasket and double checking the header bolts periodically should help. Rev- FYI: I'm sure you're familiar with the "ignition wrench" set that comes with most Craftsman tool sets, with thin open end wrenches, where one end is normal and the other opens at 90 degrees. Well, the 90 degree 3/8" wrench (or 7/16", depending on your header bolts), is a godsend when it comes to hard-to-get-to header bolts. You still can't torque them, but you know how tight to go. Anyway, that wrech allows for a greater turning radius, lessening the time and frustration that goes with installing and uninstalling header bolts! Dig through your tool box and try it! I know you'll be pleased. Take care, -Chris ------------------ Retired Moderator MustangNet My site: Peckerwoods Pit Stop My teams site: Jim Porter Racing RACECAR spelled backwards is RACECAR HEY !!! Are you ASE Certified ??? If you are, ask me about iATN.