

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
Thread Tools | Rate Thread | Display Modes |
![]() |
#2 |
Guest
Posts: n/a
|
![]() The stock E7TE castings are also legal. The GT-40 and GT-40P are legal because they were mass production vehicle heads. George would have to say whether or not the old 289 heads are legal....I've never asked. As far as the suspension goes, it has to retain its stock mounting points. You can change control arms , springs, etc within the limits of the rules as long as it retains stock appearance, functionality, and basic geometry.
I'll end this with my usual disclaimer: Always check with George if you've got even the smallest question about the legality of your combination. He's the final authority on what goes and what doesn't. ------------------ Jeff Chambers T/S #4 12.60 Seconds/109.0 MPH |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question on Stock Temp sensor? | PrplMonster | Windsor Power | 7 | 08-25-2001 10:24 AM |
What exhaust systems do the trophy stock guys run? | TJR | Windsor Power | 4 | 08-03-2001 04:55 PM |
Question on stock heads and intake | Yan88gt | Windsor Power | 1 | 06-24-2001 08:13 AM |
stock Head question | Patrick Boetticher | Windsor Power | 2 | 06-11-2001 05:02 PM |
Comp. ratio question with 58/54cc heads on stock bottom end.. | Killercanary | Windsor Power | 5 | 02-06-2001 03:51 PM |