Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-10-2001, 04:49 AM
|
#10 |
|
Registered Member
Join Date: Aug 1999
Location: England UK
Posts: 7
|
I have taken the plunge and torn the motor down now, no 7 intake valve guide is very worn, that valve shows signs of wear also.
The (loc wire) head gasket shows evidence of failure around no 8 cylinder, water has got in and corroded the aluminum in the groove quite badly. So I need the head welded, the groove re-cut, new guides installed and all the machining done, sucks big time! ps They are screw in studs |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| follow up to horrible vibration problem | Toeclicker | Windsor Power | 4 | 12-18-2003 06:38 PM |
| Please help stutering problem | Just me | Windsor Power | 10 | 10-18-2002 02:37 PM |
| bizzare problem part II | RPM427 | Windsor Power | 7 | 07-22-2002 05:21 AM |
| Bizzare problem | RPM427 | Windsor Power | 10 | 07-09-2002 11:28 AM |
| Surging Problem - Help | Lawless | Windsor Power | 32 | 08-19-2001 10:57 PM |