

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#11 |
Registered Member
Join Date: May 1999
Posts: 5,246
|
![]() 1988 5.0 LX Hatch. $2500. A little worn out. Assuming standard everyday mods have been made 90% of the time they are. 2.5" cat back, cold air, bumped timing, shifter, underdrives, clutch adjuster, 190 fuel pump.
Rebuild kit: $420 block machining: $150 Twisted Wedge heads: $900 E-303 cam: $160 1.6:1 RR: $200 TFS Intake: $400 AFPR: $100 65mm T/B: $180 cold air: $free 190lph pump: $free underdrives: $free 1 5/8" longtubes: $240 2.5" H for LT: $130 2.5" cat back: $free Pro 5.0: $free clutch adj: $free 4.10 gears: $400 installed subframes: $150 control arms: $300 clutch kit: $250 4cly springs: $20 NOS 100 shot: $400 Estimated ET (since you'd need a rollcage at the strip) mid/high 11's. Total cost: $6900. Reliable, streetable, 5.0. No stroker, no supercharger. Probably 11's w/o spray. Now, inferno I expect you can pick a FWD car (not replace the motor with anything other than stock IE: no GSR motors into a CRX otherwise we can change our **** to a 427 BB in a $800 4banger, and cut massive cost) and come somewhere close to that figure? Good luck. |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Took the Turbo Stang to the Track..... | Ackbar00 | Stang Stories | 23 | 05-04-2004 08:54 AM |
1984 Turbo Stang | 289 | Small Ponies | 0 | 06-03-2003 11:15 AM |
Turbo in n/a 2.3? | pxcr_600 | Small Ponies | 1 | 06-21-2002 12:20 PM |
Newbie going from 4banger turbo car to a 91 stang | Jerry95TSI | Windsor Power | 5 | 05-06-2002 08:28 AM |
Why not put a turbo on the 'stang? | Vector | Windsor Power | 7 | 07-30-2001 04:16 AM |