Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-09-2001, 12:10 PM
|
#7 |
|
Sniffed too much n20
Join Date: Oct 1998
Location: Ont, Canada
Posts: 1,018
|
I was on the corral.net technical calculators and according to that, you'll have 9.3:1 with the 60cc heads on the stock short block. I'm running the Edelbrock 6032 heads on an 89 shortblock, so that's close to what my compression should be.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4.6 DOHC Head porting | Nitrous Al | Modular Madness | 7 | 03-15-2003 11:23 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Well I did a compression test and it doesn't look goo for my Holley heads... | Rick 91GT | Windsor Power | 6 | 02-20-2001 07:43 AM |
| 351W Compression Ratio | BennyBoy | Windsor Power | 2 | 02-16-2001 10:23 PM |
| Comp. ratio question with 58/54cc heads on stock bottom end.. | Killercanary | Windsor Power | 5 | 02-06-2001 03:51 PM |