Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-12-2001, 03:14 AM
|
#7 |
|
Registered Member
Join Date: Feb 1999
Location: Camarillo/Thousand Oaks Ca
Posts: 223
|
Witch cam did you go with (specs?) i re used my old lifters with 92,000 on them (i should have repalces them but $$$) my trusty carquest guy said it was ok to reuse, and he also said to pour oil on the cam then put it in and then right before you put on the upper dump some oil down there throuh the lifter valley...
Good luck!!! ------------------ PPG Torch Red 95GT, Ported Explorer Intake, E-303 cam, 75mm TB,BBK adj. fuel Reg, BBK Headers,H-pipe, pulleys, flowmasters, Kenny Brown 6 point cage, panhard Bar, powerslot rotors, Eibach Springs, MSD 6AL, Master Blaster, AFS 10.5" Cobra R's, Nitto 555s ect. [This message has been edited by Patrick Boetticher (edited 02-12-2001).] |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rare Mustangs....Got One? | 1969Mach1 | Blue Oval Lounge | 22 | 09-25-2010 04:59 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Classic Mustangs | 8 | 06-16-2005 11:43 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |