Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
02-12-2001, 09:29 AM
|
#1 |
|
Moderator
Join Date: Aug 2000
Location: Milan, OH
Posts: 2,699
|
If you used the center type compressor, it should drop out through the hole in the lower A-arm. You can't use the external type spring compressors with the Mustang...you won't be able to get them out, if you can even get the springs in.
I usually don't use a spring compressor at all, but rather take out the A-arm pivot bolts and lower the inside of the A-arm with a floor jack, install the spring then jack the A-arm back up into position. ------------------ Jeff Chambers Trophy Stock #3 11.97 Seconds / 114.5 MPH Chambers Racing Team |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| compressing spring ???? | BigCountryGT | Windsor Power | 8 | 04-18-2004 09:48 PM |
| front eibach pro-kit spring installation | mtv not bullets | Windsor Power | 1 | 01-05-2004 10:05 PM |
| Front Coil Spring Installation | Mac_5.0 | Windsor Power | 4 | 05-28-2003 11:09 AM |
| Front spring help, ASAP! | Chris_H | Windsor Power | 5 | 05-12-2003 07:12 PM |
| Spring Installation | 5000Man | Windsor Power | 8 | 02-13-2002 12:08 AM |