went to trak...tooo slow! help!?!

venumus93 · 07-10-2001, 07:00 PM

E & EZRIDIN, thanks again for the advice. I had just changed the oil a week ago & I put taylor spiro pro wires & new cap & rotor on about 15-20K miles ago. never changed the fuel pump tho, will do that very soon. i put bosch platinums on there & have read on this board that copper plugs are better performing, so I may just switch to them when I do the fuel pump. The gears should be in by end of month, & I may go with the 3.73's as this will be my weekend warrior starting by the end of month. Heck, our new Explorer has 3.73's in it, why not the Cobra??? I have an old Z car that will be my daily driver, so I wont worry about gas mileage in the Cobra. As for the pullies, I didnt realize the Cobra had diff ones than the GT, but these were diff diameter than stock, especially the crank, so maybe i gained a little bit there. EZRIDIN, we should def talk at the track sometime. Melbourne is trying to build one right now, but it's going slowly, although ground has been broken already. I cant wait, a track less than 5 miles from my house! Later!

------------------
93Cobra#3974
off-road h-pipe, 2chamber flowmasters, hurst shifter, moroso cold-air induction, march street pullies

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
351w is slow and weak...please help	ka_dawg98	Windsor Power	8	10-07-2003 10:50 AM
Cobra's are slow...	Skyman	Blue Oval Lounge	17	08-23-2003 05:43 PM
1/4 trap speed too slow?	01silverstreak	Modular Madness	5	04-25-2002 12:44 PM
Cheapest place to get 4.10s and a trak lok rebuild kit?	swtstang	Windsor Power	1	07-16-2001 09:34 PM

07-10-2001, 07:00 PM	#10
venumus93 Registered Member Join Date: Jun 2001 Location: West Melbourne, FL, USA Posts: 237	E & EZRIDIN, thanks again for the advice. I had just changed the oil a week ago & I put taylor spiro pro wires & new cap & rotor on about 15-20K miles ago. never changed the fuel pump tho, will do that very soon. i put bosch platinums on there & have read on this board that copper plugs are better performing, so I may just switch to them when I do the fuel pump. The gears should be in by end of month, & I may go with the 3.73's as this will be my weekend warrior starting by the end of month. Heck, our new Explorer has 3.73's in it, why not the Cobra??? I have an old Z car that will be my daily driver, so I wont worry about gas mileage in the Cobra. As for the pullies, I didnt realize the Cobra had diff ones than the GT, but these were diff diameter than stock, especially the crank, so maybe i gained a little bit there. EZRIDIN, we should def talk at the track sometime. Melbourne is trying to build one right now, but it's going slowly, although ground has been broken already. I cant wait, a track less than 5 miles from my house! Later! ------------------ 93Cobra#3974 off-road h-pipe, 2chamber flowmasters, hurst shifter, moroso cold-air induction, march street pullies