Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-09-2001, 07:56 PM
|
#16 |
|
Registered Member
Join Date: Feb 2001
Location: Coventry R.I. U.S.
Posts: 37
|
I found my best time slip today.It was 13.175 @ 101.85 w 1.797 60ft.Honestly this engine has never been opened with stock intake,cam & mass air. I have no computer chip or nos.This car never fails to surprise me.
I think tires,stage & launch are important. I love the MT ET Streets. I pull into the water ,light spin in first just to get em wet, pull forward & heat em in second. then just barely tickle the stage beam this will give you a little extra run.Then when the green bulb pops drive it like you hate it. A lot of these combos listed have 12 second potential. I noticed a few of you are from PA. Love to get Down there some time its only about 5hrs. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ARP assembly lube and thread sealer.??? | JaxMustang50 | Windsor Power | 4 | 04-15-2003 10:18 AM |
| Dan..close This Thread..just My 2 Cents | Topless In Texas | Blue Oval Lounge | 8 | 08-02-2002 06:43 AM |
| "Why's my car so slow" Thread Deleted... | Hammer | Modular Madness | 23 | 07-09-2002 05:12 PM |
| Shift Knob Thread Size | Gautam | Blue Oval Lounge | 1 | 02-19-2001 12:48 AM |