Yet another "How much HP am I looking at" thread

Skyman · 02-10-2001, 03:48 PM

I have to say there is no way to see 310rwhp hp on stock heads that arent fully race ported with high compression. Maybe you ment to put fwhp.

Theres hethj on here he has GT40's and all the rest of the boltons and he dyno tuned it to 262rwhp. I think my car, juding by its ET, and weight is probably around 280rwhp. Now I know theres probably some more in it, but 310rwhp on stock heads no.

12sec, thats a different story. That is possible w/ a good suspension and slicks I believe. Because it wont take 300+ rwhp to do that.

Look at Mustang92, he just went 12.99@104mph with 244rwhp in a heavier car on slicks.

Skyler

------------------
-1989 Saleen Mustang #406-
TFS Heads, Edelbrock intake, E-303, 3.73's, 1 5/8 shortys, Offroad-H, 2chamber flows, 36psi FPR, 15degrees timing, 70mm tb, 73mm maf, 24lb inj, Crank pulley, MSD6A, Alum driveshaft, ripper shifter, and turndowns.
13.2@106mph

Daily Driver
STOCK-1994 Integra LS
15.48@91mph

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ARP assembly lube and thread sealer.???	JaxMustang50	Windsor Power	4	04-15-2003 10:18 AM
Dan..close This Thread..just My 2 Cents	Topless In Texas	Blue Oval Lounge	8	08-02-2002 06:43 AM
"Why's my car so slow" Thread Deleted...	Hammer	Modular Madness	23	07-09-2002 05:12 PM
Shift Knob Thread Size	Gautam	Blue Oval Lounge	1	02-19-2001 12:48 AM

02-10-2001, 03:48 PM	#20
Skyman I need 110mph Trap Speed! Join Date: Feb 1999 Location: So, CA Posts: 4,315	I have to say there is no way to see 310rwhp hp on stock heads that arent fully race ported with high compression. Maybe you ment to put fwhp. Theres hethj on here he has GT40's and all the rest of the boltons and he dyno tuned it to 262rwhp. I think my car, juding by its ET, and weight is probably around 280rwhp. Now I know theres probably some more in it, but 310rwhp on stock heads no. 12sec, thats a different story. That is possible w/ a good suspension and slicks I believe. Because it wont take 300+ rwhp to do that. Look at Mustang92, he just went 12.99@104mph with 244rwhp in a heavier car on slicks. Skyler ------------------ -1989 Saleen Mustang #406- TFS Heads, Edelbrock intake, E-303, 3.73's, 1 5/8 shortys, Offroad-H, 2chamber flows, 36psi FPR, 15degrees timing, 70mm tb, 73mm maf, 24lb inj, Crank pulley, MSD6A, Alum driveshaft, ripper shifter, and turndowns. 13.2@106mph Daily Driver STOCK-1994 Integra LS 15.48@91mph